[China Glass Net] The characteristics of the glass door are determined by the characteristics of the glass itself. For example, when tempered transparent glass is used, the door leaf has a transparent function, and when frosted glass is used, it has a semi-transparent function. Let's take a look at how to install a glass door leaf.
Cross-line
Dash the upper and lower metal rails of the glass door leaf, and fix the pin hole plate of the transition pin and the transition shaft connecting plate of the floor spring by wire. Detailed operation can be clarified with reference to the ground spring commodity device.
Determine the height of the door leaf
The height dimension of the glass door leaf should be taken care of when inserting the glass plate. Normally, the height of the glass should be less than the measurement scale of 5 mm plus the left glaze to facilitate positioning and conditioning during the installation.
The upper and lower crosspieces (multiple mirror-shaped stainless steel molding materials) are placed on the upper and lower ends of the thick glass door, and the height of the door is measured. Assume that the height of the door leaf is lacking, that is, the gap between the upper and lower sides of the door and the gap on the ground exceeds the specified value, and the glued slats can be placed in the upper and lower rails for conditioning. Assuming that the height of the door leaf exceeds the scale of the device, only the professional glass worker can cut the remaining door leaf.
Fixed up and down rails
After the height of the door is determined, the upper and lower rails can be fixed. In the two empty spaces in the glass plate and the metal rail, the small wooden strips are inserted together from both ends, tapped and stabilized, and then between the small wooden strips, the door leaf glass and the crosspiece. In the gap formed, the glass glue is injected.
Door fixing
Perform door leaf positioning device. Firstly, adjust the adjusting pin of the positioning pin on the door E beam to the plane of the beam 1-2mm, then erect the glass door leaf, and align the hole position of the transition pin connecting piece in the lower rail of the door leaf with the transformation pin of the spring. And change the door leaf to place the hole on the pin. Then turn the door leaf 90. Make it at right angles to the door frame beam, align the hole of the transition joint in the crosspiece of the door leaf with the positioning pin on the door frame beam, and insert the positioning pin into the hole about 15mm (adjust the adjusting screw on the positioning pin).
Device handle
The handle hole on the all-glass door leaf. Usually it is good to add T when ordering beforehand. Some of the handles can not be tight when inserted into the hole, and should be loose. Some of the glass glue is applied to the glass before the device is inserted into the glass; if it is inserted too loosely, some of the soft tape can be wrapped in the insert. When assembling the handle, tighten the root and the glass and tighten the fixing screws.
Women'S Fitness Yoga Wear,Women'S Seamless Yoga Wear,Women'S Yoga Wear,High Stretchy Yoga Wear
Shaoxing Yizhong Textile And Garment Co.,Ltd , https://www.yizhongsport.com